Lingenfelter LNC-003 in a 2008 Z06

[2rbotech]

I recently purchased this system but I'm having problems finding the switch. Can you please point me on the right direction. Has any one installed this on a C6 Z06? Where is this switch located? The only switch I see has 3 lines going into it. Thanks in advance!

[2rbotech]

Bump!! Somebody please help me with this.

[Tim@Lingenfelter]

Clutch Pedal Position (CPP) Sensor (MM6/MZ6)

The 2008 uses one switch for the clutch with three wires:

A - 0.35 D-GN/WH circuit number 6294 Low Reference
B - 0.35 D-BU circuit number 6306 Clutch Pedal Position Sensor Signal
C - 0.35 D-GN circuit number 6293 5V


You should be able to check B (dark blue wire) and make sure you get a 5 volt signal when the clutch pedal is depressed. If its correct then you would wire a 5 volt relay off B to trigger the yellow trigger wire on the LNC-003. :biggrin:


http://www.lingenfelter.com/Forum/15332132%20GM.bmp

CPP Connector # 88953364

[2rbotech]

Ok. Thanks!

[2rbotech]

Ok. These are my findings. The "0.35 D-BU circuit number 6306 Clutch Pedal Position Sensor Signal" (B dark blue wire) is showing a 4v at unpressed position and 1v when depressed. Any other suggestions? TPS maybe?

[Tim@Lingenfelter]

We are going to locate a suppler of a 4v relay to use on the newer C6 Corvette with only a single shared switch on the clutch pedal that supplies a signal for both clutch & cruise. Otherwise you would need to install another stand alone clutch switch to trigger the launch control.

[Tim@Lingenfelter]

We have a 4v switch that can be wired inline with the clutch position switch to activate the LNC Launch controllers on the 2008 and newer Corvette. The switch is $69.00 and part number NO-00-61002.

[2rbotech]

Hi Tim, do you have a tracking number? I still haven't receive the switch.