C4 Corvette LPE headers and 213 spec sheet

[SlipNSlideVette]

Hello,

I've been running one of your combinations and really enjoying. However I no longer can find my cam card nor any information on my headers.

I have the LPE 1 5/8" primary long tube headers and y-pipe that you guys used to make on my 86 Corvette. Is there a product sheet that has header length, collecter size, that I could get? I'd llike to know this for dyno simulations but also to have in the binder that goes with the car.

Same with the 213 flat-tapet camshaft. I used to be able to pull up specs a long time ago, but not anymore. I don't need the exact specs to my cam (though I might have the numbers off the end of it written down somewhere) just a cam card would work.

Hopefully you guys have that stuff somewhere. Thanks I would really appreciate it.

Chris

[Ryan@Lingenfelter]

Hi Chris,
We really do not have a product sheet on the headers. I did find out that you could get these headers in 1 5/8" or 1 3/4" primaries, they had a 2 1/2" collector, and a 3" y-pipe. As for the cam, duration @ .050 is 224/234, lift with 1.5 rocker ratio is 465/488 (with 1.6 rockers it is 496/ 520) and center line is 112.

I hope this helps you out.


Ryan

[SlipNSlideVette]

Thanks, that is perfect!